Deutz engine TD/TCD 2012-2013 L04/06 2V Fault codes

Deutz Diagnostic Trouble Code

123	Access to a lamp of temperature of cooling of a liquid - Incorrect signal, exceeds a device control time
126	speed adjustment (pedal) - Wrong / fuzzy signal
128	Signal of intake air temperature sensor incorrect
133	Temperature sensor Transmission oil Wrong signal
134	Rail pressure monitoring system Pressure signal drop / pressure deviation out of range
135	output to the oil pressure of the control lamp Incorrect signal, exceeds the device control time Exit from the fuel metering valve block Incorrect signal, exceeds the device control time
136	Air pressure control in the air filter is too small
137	Drive output Short circuit to positive
138	Drive output Short circuit on housing
142	Access to engine lamp Wrong signal, longer than device control time
143	Rocker switch 1/2/3 Wrong / fuzzy signal
144	Lube oil temperature sensor Wrong / fuzzy signal Oil temperature control Temperature out of range
145	Automatic start switch lockout
146	Pressure reducing valve open / required pressure / pressure pressure after pressure does not open
147	Rail pressure sensor Wrong signal pressure deviation out of range
231	Oil pressure control Pressure out of range
232	Coolant temperature control - Temperature above specified range
233	adjusts the temperature of the intake air above a predetermined temperature range
235	coolant level below set level
237	control of fuel temperature Temperature outside the specified range Output 238 to the drive Fan 1/2 Invalid signal, exceeds the control time of the device Controls the fan speed out of range
241	combustion control detected misfire in one or more cylinders
261	to control actuators Relay does not open or short to ground
263	Access to cold start devices Incorrect signal failure relay, or Not connected, short circuit
271	CAN Bus timeout for one or more transmitted data blocks, inactive bus
282	Sensor supply voltage 1/2/3 Voltage out of specified range
292	Atmospheric Pressure Sensor Wrong / Fuzzy Signal
314	hydraulic system of the oil temperature sensor Incorrect regulation of the temperature of the oil in the hydraulic system Temperature set by range
318	Battery voltage out of range (lower or higher)
328	Access to lamp control device facilitates cold start. Invalid signal exceeds device control time.
414	Output to external device AGR Wrong signal
415	Output to external AGR device Invalid signal, exceeds device control time
416	Output to external device AGR Device Incorrect signal
417	Wear of a lubricating oil chronometer has reached a critical moment
512	output to the starter relay. Invalid signal exceeds device control time.
513	Access to lamp pointer Invalid signal, longer than device control time
514	signal from control terminal 15 (ignition supply wire) not detected
515	control terminal 50 detected a constant signal (wire to start the starter)
521	Measurement speed Movement speed incomprehensible
528	Access to the internal engine brake Wrong signal